Engineer loadout · Season 5 Older patch: made in an earlier patch, so some upgrades may perform differently today.

Hyperalloy Assembly & Roll Control

by JACKTHEPROSLEGEND · Updated 18 Aug 2025

Salutes · 1

Weapons & gear

Primary · Submachine Gun

"Stubby" Voltaic SMG

Upgrade code:33111

Balanced overclock Hyperalloy Assembly

  1. T1 · C Expanded Ammo Bags +120 Max Ammo
  2. T2 · C Improved Gas System +3 Rate of Fire
  3. T3 · A High Velocity Rounds +3 Direct Damage
  4. T4 · A Hollow-Point Bullets +25% Weakpoint Bonus
  5. T5 · A Magazine Capacity Tweak +20 Magazine Size
  6. OC Hyperalloy Assembly Balanced · +30% Weakpoint Bonus, x0.3 Base Spread, -50% Max Spread, and x0.2 Horizontal Recoil in exchange for -10 Magazine Size, x1.5 Vertical Recoil, and +1.5 Recoil Mass.
Secondary · Heavy Weapon

Breach Cutter

Upgrade code:23122

Clean overclock Roll Control

  1. T1 · B High Capacity Magazine +3 Magazine Size
  2. T2 · C Loosened Node Cohesion +1.5 Plasma Beam Width (equipment-terminal units).
  3. T3 · A Quick Deploy -0.2 Plasma Expansion Delay
  4. T4 · B Disruptive Frequency Tuning +100% Stun Chance, 3 sec Stun duration
  5. T5 · B Plasma Trail Leaves behind a Persistent Plasma field that does an average of 20 Fire Damage per second for 4.6 seconds. The Plasma field's width is 2/3 of the beam's width, and extends along the entire length of the beam's path.
  6. OC Roll Control Clean · After the line expands, it will begin rolling at 1200 degrees per second (3.33 full circles/sec). Holding down the trigger after the line leaves the gun allows you to influence the path the spinning projectile takes, similar to the Hurricane Guided Rocket Launcher. On release of the trigger, it will continue flying in a straight line. In addition, +0.5 Projectile Lifetime.

Comments